Car clutch maintenance is very important, the three step to teach you to troubleshootAutomobile clutch plays an important role in automobile parts. It plays an important role in ensuring the smooth start of the car, realizing the smooth shift and preventing the transmission from overloading. In the process of car driving, the owner wants to drive freely, the importance of car clutch can not be ignored. Once the automobile clutch fails, it may endanger the safety of life. Therefore, the maintenance of the clutch is an integral part of the car maintenance.First, the phenomenon of failureWhen the engine is idle, the clutch pedal has been stamped in the end, but the gears are difficult to swing. Barely put on the block, the clutch pedal has not been released, the car has been running or flameout.Two, checkRemove the clutch cover, place the transmission in neutral and push the clutch to the end. Then, drive the driven plate with a screwdriver. If you can easily turn, shows good clutch; if the call does not move, that clutch is not complete.Three, exclude
1, check the clutch pedal free travel is too large, and adjust.
2, check the separation lever height is consistent, whether or not too low. In the car shifting fork, separating the bearing end gently against the release lever on the inner end surface, turning clutch a week to view, if the separation of the inner end of the lever and separation of bearing contact is not on, indicating a high degree of leverage separation is not consistent, should be adjusted. If the separation lever is highly consistent and still incomplete, check the lever height. Separate the lever to the same height, and if it is completely removed, it will show that the adjustment is improper or worn out. Once the lever has been adjusted, the free travel of the clutch pedal must be readjusted.
3, if the adjustment is normal, still not completely separated, we must remove the clutch, check whether the installed anti driven disc, axial movement is difficult, the driven disk warping, separation lever screw is loose, floating pin is off.4, for the new riveted friction clutch, to check the driven plate and friction plate is too thick. If it is too thick, add shims between the clutch cover and the flywheel.5, for hydraulic clutch, in addition to the above inspection, but also check the brake fluid is missing, the pipe leaks and discharge the air in the hydraulic system.